RIP動態路由協議配置過程

1、1、跟據拓?fù)鋱D拖動R、S、PC到工作區1T2. 16. 1.0/24Switch 0172. 16.3.22/24PC-PT PCI2621XMRouterO2621XMRouterl0/1356024PS Multi I aye2、配置PC和R,然后連線（連線的時候請記錄所選接口），如上圖3、配置交換機%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up

2、 SwitchenableSwitch#configure terminalEnter configuration commands, one per line. End with CNTL/Z.Switch(config)#hostname s3550s3550(config)#vlan 10s3550(config-vlan)#exits3550(config)#vlan 50s3550(config-vlan)#exits3550(config)#interface f0/1s3550(config-if)#switchport access vlan 50s3550(config-if

3、)#exits3550(config)#interface f0/2s3550(config-if)#switchport access vlan 10s3550(config-if)#exits3550(config-if)#interface vlan 10s3550(config-if)#ip add 172.16.1.2 255.255.255.0s3550(config-if)#no shuts3550(config-if)#exits3550(config)#interface vlan 50s3550(config-if)#ip address 172.16.5.1 255.25

4、5.255.0s3550(config-if)#no shutdowns3550(config-if)#exits3550(config)#exits3550#%SYS-5-CONFIG_I: Configured from console by console驗證：s3550#show vlan路由器的基本配置R1R2配置RIP V2協議：配置S3550上RIP V2協議s3550#enables3550#configure terminalEnter configuration commands, one per line. End with CNTL/Z. s3550(config)#r

5、outer rips3550(config-router)#network 172.16.1.0s3550(config-router)#network 172.16.2.0 s3550(config-router)#version 2s3550(config-router)#no auto-summarys3550(config-router)#配置R1上RIP V2協議RouterenableRouter#configure terminalEnter configuration commands, one per line. End with CNTL/Z.Router(config)#

6、interface FastEthernet0/0Router(config-if)#no shutdown%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to upRouter(config-if)#ip address 172.16.3.1 255.255.0.0Router(config-if)#ip address 172.16.3.1 255.255.

7、255.0Router(config-if)#Router(config-if)#exitRouter(config)#interface Serial0/0Router(config-if)#%LINK-5-CHANGED: Interface Serial0/0, changed state to upno shutdownRouter(config-if)#clock rate 1000000Router(config-if)#%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to upip address 172.16.2.2 255.255.255.0Router(config-if)#Router(config-if)#exitRouter(config)#router ripRouter(config-router)#network 172.16.2.0Router(config-rout