TITPL7407L七路高壓大電流NMOS驅動器解決方案

1、TI公司的TPL7407L是七路高壓大電路NMOS晶體管陣列,每路輸出電流高達600mA,輸出電壓40V,輸出漏電流小于10nA,控制邏輯1.8V-5.0V,主要用混合電力汽車電池管理, 電動汽車充電器, 馬達控制,太陽能逆變器,家用電器,打印機,示波器,通信/服務器電源等.本文介紹了TPL7407L 主要特性, 簡化電路圖和多種應用電路.以及評估板TPL7407LEVM主要特性,單路電路圖和完整電路圖與PCB元件布局圖. Alps Electric Analog Devices IR (International Rectifier) JRC / NJR KEC OTAX RFMD Sams

2、ung Electro-Mechanics Seoul Semiconductor TI (Texas Instruments) Walsin Technology The TPL7407L is a high-voltage, high-current NMOS transistor array. This device consists of seven NMOS transistors that feature high-voltage outputs with common-cathode clamp diodes for switching inductive loads. The

3、maximum drain-current rating of a single NMOS channel is 600 mA. New regulation and drive circuitry added to give maximum drive strength across all GPIO ranges (1.8V-5.0V).The transistors can be paralleled for higher current capability.The TPL7407Ls key benefit is its improved power efficiency and l

4、ower leakage than a Bipolar Darlington Implementation. With the lower VOLthe user is dissipating less than half the power than traditional relay drivers with currents less than 250mA per channel.TPL7407L 主要特性:600mA-Rated Drain Current (Per Channel)CMOS Pin-to-Pin Improvement of 7-channel Darlington

5、Array (e.g. ULN2003A)Power Efficient (Very low VOL)Less Than 4 Times Lower VOLat 100mA Than Darlington ArrrayVery Low Output Leakage 10nA Per ChannelExtended Ambient Temperature Range:TA= 40 to 125High-Voltage Outputs 40VCompatible with 1.8V to 5.0V Micro-controllers and Logic InterfaceInternal Free

6、-wheeling Diodes for Inductive Kick-back ProtectionInput Pull-down Resistors Allows Tri-stating the Input DriverInput RC-Snubber to Eliminate Spurious Operation in Noisy EnvironmentInductive Load Driver ApplicationsESD Protection Exceeds JESD 222kV HBM, 500V CDMAvailable in 16-pin SOIC and TSSOP Pac

7、kages傲壹電子電子元器件分銷商 官網： 中文網： TPL7407L主要應用:Battery Management: High Cell Count for HEVEV HEV Charger: Level 3Motor Control: AC InductionMotor Control: Brushless DCMotor Control: Permanent MagnetOscilloscopePrinterSolar Power InvertersWashing Machine: Low-EndEV H

8、EV Charger: Level 1 & 2HVAC - Heating, Ventilating, and Air ConditioningMotor Control: Brushed DCMotor Control: Low-VoltageMotor Control: Stepper MotorPower: Telecom/Server AC/DC Supply: Dual Controller: AnalogRefrigeratorWashing Machine: High-End圖1. TPL7407L簡化電路圖圖2. TPL7407L步進馬達驅動電路圖圖3. TPL7407L多用圖

9、沉驅動電路圖圖4. TPL7407L 24V繼電器驅動電路圖評估板TPL7407LEVMThe TPL7407LEVM is 7-Channel relay and Inductive load sink driver evaluation module that demonstrates the integrated circuit TPL7407LDR. The TPL7407LDR is a high-performance peripheral driver designed to drive loads of many types including relays, stepper

10、motors, lamps, and light emitting diodes.This EVM is configured with seven push buttons that supply input to the TPL7407L driver and seven relays are driven by the TPL7407L outputs. A four terminal block must be connected to external power supplies to provide input and relay power. All of the TPL740

11、7L input and output pins are accessible for external connection.圖5: 評估板TPL7407LEVM外形圖評估板TPL7407LEVM主要特性:Seven numbered push-buttons control input for easy basic device testingThree 0.1” spaced post connector ports allow access to all input and output pins and relay contacts Three open locations per channel on circuit board for user supplied components Onboard relay loads can be disconnected by removing surface mount zero ohm resistors