臥龍牌電動(dòng)車自行車使用說明書WolongelectricvehicleBicyclemanual

1、臥龍牌電動(dòng)車自行車使用說明書( Wolong electricvehicle Bicycle manual )臥龍牌電動(dòng)車自行車使用說明書 (Wolong electric vehicle Bicycle manual)Vehicle safety requirementsFirst, the main components of electric bicycle operation1 、 power switch, power switch is the main power supply circuit switch, when placed in the "open"

2、 position, the power supply system is switched on, the monitor power indicator light, in the "off" position, the system power supply is cut off. Attention: when the vehicle appears the unusual phenomenon, must certainly switch off the power switch promptly, in order to avoid the accident t

3、o expand further. 2, emergency stop switch, some models of electric bicycle, in the speed control handle next to the emergency stop switch, in the riding process in case of emergency, timely press the emergency stop switch and brake brake.3, speed control, turn the speed, turn the installation on th

4、e right side of the handlebar, through the rotation can smoothly adjust the speed of the electric vehicle.4, brake handle brake handle operation and operation of ordinary bicycle, electric bicycle brake is different with the brake power-off device, when the micro switch operation to brake in the bra

5、ke fashion, the output signal to the controller, the controller controls the motor power supply, cut off, the motor stops working.5, display deviceThe electric bicycle has a display device, such as power, power, speed, etc. when the power is on, the indicator light is on and the voltmeter rises to t

6、he current voltage (the display data is for reference only).Two, before riding inspection 1, with double support to set up electric bicycles, turn on the power switch, check the electrical performance, speed control hand, power brake handle is normal.2, the battery box lock is locked, after the powe

7、r supply, the display device is normal.3, check the adequacy of the tire gas, otherwise it will affect the mileage or cause tire damage.4, check whether the abnormal braking system, steering lamp and warming device is normal.Three, operation and maintenance, after checking the normal, open the elect

8、ric bicycle double support, sitting on the saddle, right hand gently rotating speed, hand electric bicycle slowly start, driving skills and ordinary bicycle basically the same.1, when riding will be opened by the key switch (clockwise rotation a set open position), display panel power indicator, sai

9、d power on. Some models will be key to continue in the second turn clockwise. You can turn on the headlights.In 2, the red button on the right side of a speed adjustinghandle for cruise control switch, the operation of electric vehicles when the switch is pressed, the output state control handle is

10、locked at a speed adjusting handle will not work, the vehicle lock handle state value operation, this can open speed in hand, is conducive to the long time riding electric reduce hand fatigue again press the switch once or use the brakes will unlock state.3, in the process of driving, as the power c

11、onsumption, the voltage indicator on the display panel, voltage indicator gradually declined. When down to the undervoltage protection value, it means that the battery is running out and should be switched on by foot. The battery needs recharging before use. The controller will automatically cut off

12、 the motor power supply if the battery is used after it is exhausted.4, only when the rider pedal electric driving feet, not carrying children or stand.5, in turn, do not bend the inside pedal at the lowest point, otherwise it may make the pedal contact with the ground, and cause the dumping of vehi

13、cles.6, one charge continues mileage, with the traffic conditions, load, wind direction and other factors will be different. On the uphill, crossing, starting repeatedly and moving against the wind, it is recommended that foot assistance is often used. In order to avoid excessive power consumption a

14、nd increase mileage. And the motor, battery life is good.7, in most of the models in Wolong, with pedal power function.Do not adjust the speed regulation handle, direct ride, the controller detects the rider pedal speed control motor output, output ratio of motor in the vehicle before leaving the fa

15、ctory has been adjusted, which help to increase the riding continued mileage and exercise.8, after use, must close the electric door lock, remove the ignition key.9, Wolong brand electric bicycle with daily water resistance, rainy day driving on the water surface, the water depth should not exceed t

16、he electric bicycle controller and wheel center position, otherwise the motor or controller fault caused by water seepage may.10, the whole vehicle should be avoided in the air humidity, humidity and corrosive gas in place, so as not to make the metal parts of electroplating, paint surface chemical

17、corrosion.11, the vehicle should avoid prolonged exposure to the sun and rain, so as to avoid damage to components in the controller, resulting in failure to operate, accidents.12, the controller construction complex, users should not be allowed to dismantle, repair.13, electric bicycles feel heavie

18、r when they go back. Normal riding heavier than ordinary bicycles, riding in the motor has a small amount of noise are normal.14, riding should not overload, should not put heavy goods and bring people, so as not to damage the battery, motor and controller.15, electric bicycle lubrication is an impo

19、rtant part of maintaining electric bicycles. According to the use, the front axle, rear axle, center axle, flywheel, front fork and other rotating parts should be scrubbed and lubricated every six months to one year (recommended using molybdenum disulfide grease). Electric hub for free maintenance p

20、arts, users do not have to wash oil. Found unusual circumstances, to our company special repair points for maintenance.The fourth chapter is the adjustment method of productsFirst, the battery box installation, whether Ling series or long series of electric bicycles. Its design is different, the bat

21、tery box placement position is different, but each electric bicycle has mechanical lock, locking battery box. When the battery is removed, recharge and return to the electric bike, remember to lock the battery box.Two, saddle adjustment 1, saddle height should be riding on the saddle, feet and groun

22、d contact is appropriate.2, adjust the saddle height, pay attention to the safety line on the saddle should not show. And note that the fastening torque of the saddle clamping nut and the saddle pipe clamping bolt is not less than 18N.m.Three, handlebar adjustment1, at the front of the handlebar. Th

23、e two legs clamp the front wheels and the two hands grip the handlebars. Adjust the handlebar cross tube to the car body 90 degrees. Lock the handle and hang the bolt2, adjust the handle height, pay attention to the riser safety line should not show, and pay attention to hanging bolts and fastening

24、bolts, torque is not less than 18N.mFour, cantilever brake adjustment 1, check the right brake handle, when the brake handle of the stroke of 1/2X, should achieve full braking.2. Loosen the screw on the brake wire holder and then pull or loosen the brake wire. On both sides of the brake block from t

25、he rim with an average distance of 1.52mm and then tighten the screws, adjusted repeatedly until reaching the standard requirements.Five, brake (brake) adjustment 1, check the left brake, when the brake handle travel up to 1/2X, should reach full braking.2. Turn the adjusting screw counterclockwise,

26、 then press the nut behind the adjusting screw clockwise. Secure. Forward adjusting screw, the brake is tight. If the brake has been transferred too tight, according to the reverse rotation adjustment screw and a fixing nut, can loosen the brake. Adjust repeatedly to standard requirements. Note that

27、 the adjusting screw extends from the right side of the bracket to no less than 4mm. If the above method is out of range, you can reset the adjusting screw and loosen the tightening screw, then pull orloosen the brake wire. Finally, tighten the screw and adjust the brake to the standard requirement.

28、Six, adjust the chain of vehicle riding after a period of time, sometimes the chain will loose, the adjustment method is as follows: remove the plastic sheath on both sides of the rear axle, and the two locking nut is loose, if loose chain, with two adjustable chain nut clockwise adjustment on both

29、sides, until the chain elastic moderate, pay attention to the regulation the same frame should ensure that the rear plane parallel, and finally the lock nut, mounted on a plastic protective sleeve can be. If the chain is tight. Adjust the adjusting nut counter clockwise according to the method of ap

30、peal and move the rear wheel slightly forward. If the user can not adjust, to the company special repair points to adjust.Seven, the main fastener torque indicator should periodically check the recommended adjustments, such as: the main fasteners and accessories fork lock nut, front and rear wheel,

31、a saddle, handlebar, brake and other fasteners and accessories inspection and adjustment.Name fastening torque name fastening torqueSaddle front wheel is greater than or equal to 18N.m = 18N.mSaddle tube is larger than 18N.m rear wheel is greater than or equal to 30N.mThe riser is greater than or eq

32、ual to 18N.m axis nut is greater thanor equal to 30N.mThe horizontal tube is larger than 18N.mThe fifth chapter, the correct use method of the four piecesA charger 1, Wolong brand electric bicycle equipped with electric bicycle charger, there are two main types of charger, a common charger, charging

33、 three stepcharging - constant current and constant voltage and floating charge; one is pulse charging charging mode, is the "gold combination" charger.2. The power battery of Wolong brand electric bicycle must be charged with the charger provided by the company. When charging, check the p

34、ower supply voltage of the charger and match the local voltage.3, for the power supply voltage instability area (refers to the power grid fluctuations of more than + 10%), it is recommended to use AC voltage regulator, otherwise it is easy to cause the charger or the charger overload fuse.4, when th

35、e battery needs to be charged, it can be charged on the vehicle. It can also open the mechanical lock of the battery box on the vehicle, remove the battery box from the car and bring it to the place where the power is supplied.5, charging time. Insert the charging plug on the charger into the batter

36、y box or the charging socket of the vehicle, then plug the charger power plug into the AC power outlet,At this point, the charging indicator light is on, indicatingthat the charge is being completed, if the car charging, we must ensure that the car power switch closed.The light changes 6, the charge

37、r (such as: changed from red to green), said that the battery is sufficient, then the charger will be automatically transferred to the constant voltage charging state, under normal circumstances, according to the power consumption of battery charging time is not more than 12 hours, if more than 12 h

38、ours charging time, charging indicator light does not change, should be immediately stop charging, send special maintenance testing company.7, constant pressure in the floating state (such as: green indicator lights), even if the long time does not damage the battery charging. The float is not the b

39、est time for less than 2 hours. Make sure the battery is charged more.8, charging end, first unplug the power plug, and then the charger output plug from the charger socket pull out.9, lead-acid batteries excessive discharge will affect the battery life, the battery in the absence of electricity, lo

40、ng-term charging will cause the battery water loss, affecting the battery life. Recommendation: use the charge about 15km. If the battery is not used for a long time, it should be stored in the condition of sufficient electricity and charged once a month.10, charging, charger, battery box should be

41、placed smoothly, prevention and control of falling. The charger and battery case cannot be covered. Heat dissipation by ventilation. Caution:do not touch the battery box electrode with wet hands! 11, charging, such as found that the battery box surface temperature is too high (higher than 45 degrees

42、 C), indicating that the box battery or charger is faulty, should immediately cut off the power supply, send our company special repair point maintenance.12, the battery life after the termination, the user can go to our company special repair point to replace the old, waste batteries must be recove

43、red, the user shall not be allowed to deal with their own waste batteries, so as not to cause two pollution.Be careful The specific use of charger, see the charger with instructions.Two 、 motor1, Wolong brand electric bicycle adopts rare earth permanent magnet DC motor, the type of motor: brush moto

44、r and brushless motor two kinds. From the appearance of motor to distinguish: motor, one spoke wheel motor, general motors, KINGBOX motor, motor for electric bicycles of different styles with different, according to the market requirementsand the needs of users, the same type of electric bicycle wit

45、h motor is not necessarily identical.2, the motor does not need special maintenance at ordinary times, in the electric bicycle running 2000h cumulative, please go to our company special repair points for maintenance.3, brush high-speed motors, brushless motor start process, there is a slight noise i

46、s a normal phenomenon.4, rainy days in the water road, the depth of water is not more than the motor center of the case can be normal driving, otherwise it may cause motor seepage and damage to the motor.Caution: under no circumstances shall hand or other objects be inserted between wheel axles to a

47、void damage to vehicles and personnel. Three 、 controller controller is the electricsystem control center of electric bicycle, mainly stepless speed regulation, brake power off protection, over-current protection, undervoltage protection, lighting system control, display and other functions.1, Wolon

48、g brand electric bicycle factory controller instructions have been adjusted,Please do not make any random adjustments.2, most of the car controller has pedal assistant function.3, with people traveling or long uphill ride, the controller running current will increase, heating, serious may burn out t

49、he controller, so in a larger slope and longer road on the road, please use pedal power.4, electric bicycles in the parking, not in the sun exposure, not to rain for a long time, so as to avoid the controller fault.Four, 1, Wolong brand electric bicycle battery used lead-acidelectric bicycle special (or lead crystal) maintenance free batteries, each car battery br