夏普GP2Y1010AU0F_粉塵傳感器參考程序

1、夏普GP2Y1010AU0F粉塵傳感器參考程序簡介：Sharps GP2 Y1010AU0F是一款光學空氣質量傳感器，設計用來感應空氣中的塵埃粒子，其內部對角安放著紅外線發光二極管和光電晶體 管，使得其能夠探測到空氣中塵埃反射光，即使非常細小的如煙草煙霧 顆粒也能夠被檢測到，通常在空氣凈化系統中應用。該傳感器具有非常低的電流消耗（最大20mA典型值11mA ,可使用高達7VDC該傳感器輸出為模擬電壓，其值與粉塵濃度成正比?？蓽y量0.8微米以上的微笑粒子，感知煙草產生的咽氣和花粉，房屋粉塵 等.體積小,重量輕,便于安裝，廣泛應用于空氣清新機，換氣空調，換氣 扇等產品.靈敏度：30.5V/0.1m

2、g/m尺寸：46.0 X 30.0 X 仃.6 mm）77R=150QtAAA-+777 C=220nFDo not miss the 150ohm resistor and a 220uF capacitorSensorPinArduino Pin1Vled5V(150ohmresistor)2LED-GNDGND3LEDDigital pin 24S-GNDGND5VoAn alog pin 06Vcc5VrecieveThe LED pin has to be modulated with a cycle of 1ms as discussed in the datasheet.The

3、LEDseems to use a PNPtransistor so to power on, the LEDpin must actually a lower dustP in=0;int dustVal=0;int ledPower=2; int delayTime=280;int delayTime2=40;float offTime=9680;void setup()Serial.begi n(9600);pinM ode(ledPower,OUTPUT);pi nM ode(4, OUTPUT);void loop()/ ledPower is any dig

4、ital pin on the ardu inoconn ected to Pin 3 on the sen sor digitalWrite(ledPower,LOW); / power on the LED delayMicrosec on ds(delayTime);dustVal=analogRead(dustPin);/ read the dustvalue via pin 5 on the sen sor delayMicrosec on ds(delayTime2);digitalWrite(ledPower,HIGH); / turn the LEDoff delayMicrosec on ds(offTime);delay(3000);Serial.pri ntln (dustV