夏普GP2Y1010AU0F_粉塵傳感器參考程序

1、精選文檔夏普GP2Y1010AU0F_粉塵傳感器參考程序簡介： Sharp's GP2Y1010AU0F 是一款光學空氣質量傳感器，設計用來感應空氣中的塵埃粒子，其內部對角安放著紅外線發光二極管和光電晶體管，使得其能夠探測到空氣中塵埃反射光，即使非常細小的如煙草煙霧顆粒也能夠被檢測到，通常在空氣凈化系統中應用。該傳感器具有非常低的電流消耗（最大20mA，典型值11mA），可使用高達7VDC。該傳感器輸出為模擬電壓，其值與粉塵濃度成正比?？蓽y(cè)量0.8微米以上的微笑粒子,感知煙草產生的咽氣和花粉,房屋粉塵等.體積小,重量輕,便于安裝，廣泛應用于空氣清新機,換氣空調,換氣扇等產品.

2、靈敏度：0.5V/0.1mg/m3尺寸:46.0 × 30.0 × 17.6 mm) Do not miss the 150ohm resistor and a 220uF capacitor Sensor PinArduino Pin1Vled>5V (150ohm resistor)2LED-GND>GND3LED>Digital pin 24S-GND>GND5Vo>Analog pin 06Vcc>5V The LED pin has to be modulated with a cycle of 1

3、ms as discussed in the datasheet.The LED seems to use a PNP transistor so to power on, the LED pin must actually recieve a lower voltage. 例程;int dustPin=0;int dustVal=0;int ledPower=2;int delayTime=280;int delayTime2=40;float offTime=9680;void setup()Serial.begin(9600);pinMode(ledPower,OUTPUT);

4、pinMode(4, OUTPUT);void loop()/ ledPower is any digital pin on the arduino connected to Pin 3 on the sensordigitalWrite(ledPower,LOW); / power on the LEDdelayMicroseconds(delayTime);dustVal=analogRead(dustPin); / read the dust value via pin 5 on the sensordelayMicroseconds(delayTime2);digitalWrite(ledPower,HIGH); / turn the LED offdelay