隔熱膜施工工藝及過程

1、China中國Window film construction meithods and process太陽隔熱膜施工工藝及過程WINDOW FILM CONSTRUCTIONMETHODS AND PROCESS太陽隔熱膜施工工藝及過程ChinaWindow film construction meithods and process中國太陽隔熱膜施工工藝及過程Preparation at the construction site1、在施工現場準備Determine construction areas according to construction drawings and make

2、 preparation of construction in teams.確定建筑面積按施工圖紙，并在團隊中的施工準備。Determine material stacking and blanking locations.確定材料堆放和下料位置。Check construction tools and safety measures, such as ladder safety etc.檢查施工機具和安全的措施，如梯子安全等，F(xiàn)urther make preparation for protection and prevention.進一步做好保護和預防的準備Construction met

3、hods2、施工方法Glass cleaning清潔窗戶Check whether there are any dirty marks such as soil dust, paints or silicone glue on glasses before spraying and wetting glasses. Use scouring pad to remove the dirt as necessary and clear away the dust with brushes. Spray washing and installation liquid on the whole gla

4、ss,and use the cleaning scouring pad to clean the whole window glass. Use the clean dish cloth to clean the window frames.在噴濕窗子之前，先檢查玻璃上是否有泥塵、油漆、或硅酮膠等污物。 必要時用刀片將污物清除，然后用硬刷把塵埃掃去。將整快玻璃噴上清洗安裝液，然后用清鏟刀將整個窗玻璃刮 鏟。用一塊柔軟的毛巾擦洗窗框四周，把窗框邊緣擦洗干凈。Window film preparation2.2 準備窗膜Currently three common methods are use

5、d to prepare window film.目前有三種常用的方法準備窗膜Method 1: Use other glass as the backer.C h I n QWindow film construction meithods and process中國太陽隔熱膜施工工藝及過程方法1 :以其他窗戶為墊板，Use a piece of glass that has been cleaned initially as the backer, sprinkle water on the window and place the window film to be installed

6、on it. The protective film of the window film shall be placed towards yourself.先找一個初步清潔的窗子做墊板，在窗上灑水后，把將要安裝的窗膜置于其上，窗膜的保護膜面向自己。Method 2: Reversal roll method方法2：反轉卷軸法Roll the window film reversedly towards the box side carefully, with the protective film facing upwards. The rolling diameter of window

7、film shall be about 2.5cm. While about 8cm long window film is left after rolling, cut the film along the box edge. Grip the rolled window film at hands,and then start to tear protective film. Tear the film carefully, and roll the protective fill towards the roll core. Spray installation liquid to g

8、lue it and prepare for installation.細心地將窗膜以保護膜向上的方式反卷至盒邊，窗膜卷徑應約為2.5cm。當窗膜卷剩8cm時，在窗膜的前后噴清洗安裝液。把卷好的窗膜握在手中，然后開始撕下保護膜。小心地撕，讓保護層卷向卷軸。在撕下保護膜的8cm范圍，將清洗安裝液噴灑在安裝膠上，接著把窗膜卷暫時放置于一干凈之處。Method 3: Double-person installation method方法3;雙人安裝法One person will clean the window, and the other person will measure windows

9、and prepare window films. When one person stretches the window films out of the box to appropriate length, the other person can cut the window film. After having separating the protective film of the window film a little form the top of window films, staff A grips two top corner of the window film a

10、nd staff B tear the protective film slowly and spray the washing and cleaning liquid on the installation glue at the same time. Staff B can continue spray washing and spraying liquid on the glass window and then staff A can install the window film on to the window glass.其中一人先清潔窗戶，而另一人則度量窗戶和準備窗膜。當一人把

11、窗膜從盒中拉出至適當長ChinaWindow film construction meithods and process中國太陽隔熱膜施工工藝及過程度時，另一人可以把窗膜切下。把窗膜的保護膜從窗膜上端分開少許后，工作人員甲握住窗膜兩個頂角，由乙則慢慢地把保護底膜撕下，同時在安裝膠上噴灑清洗安裝液。乙可以繼續在玻璃窗上噴灑清洗安裝液，之后甲可以把窗膜鋪帖到窗玻璃上。Final washing before insaaion鋪帖前的“最后清洗”Spray cleaning and installation liquid evenly on the whole glass to form a la

12、yer of mist, and use the rubber wiper strip to scrape the window glass from the window top through S-shaped motion. Be very careful to avoid leaving any dust mark on the glass while start dragging the scraping mop after it pauses. 將清洗安裝液均勻地在整面玻璃上噴灑一層薄霧，用普通刮擦拖把由玻璃的上方以連續的橫向動作掛擦窗玻璃。在掛擦拖把停頓后再開始拖動時， 要格外小

13、心，以免在玻璃上留下塵埃痕跡。Installation of window films鋪帖窗膜Spray a proper amount of installation liquid on the whole glass except 5cm range on the top. There shall be no dry places where no installation liquid is sprayed, or the window film will stick too early during installation, which will make you fail to s

14、lip the window film to appropriate positions.除了最頂端的5cm范圍之外，將整面玻璃均勻地噴上適量清洗安裝液，玻璃上不能有沒有 噴到的地方，否則安裝時窗膜會太早黏住，使你無法將窗膜滑向適當?shù)牡胤?。The first water squeezing擠壓水份Spray the washing and installation liquid on the film surface. Starting from the top in the middle of the window film, move the tough squeezing plate u

15、pwards, downwards, leftwards and rightwards, and use the samepressure and angle and overlapping motion to squeeze the whole glass, or there will be water stain be left. Pay attention that no water squeezing is conducted within the 5cm range from the sides.再度向?qū)χ覂?nèi)的膜面噴灑清洗安裝液。由窗膜中上方開始，上下左右地移動堅硬擠壓拖把，4Ch

16、inaWindow film construction meithods and process中國太陽隔熱膜施工工藝及過程用相同的壓力及角度、重疊的動作擠壓整塊玻璃，否則將會遺留水漬。Cutting the side window film裁切邊部窗膜Use a pentagonal guide plate to stand over the glass vertically, and then use the blade tocut four sides of the window film. The sides of window film must be cut before fina

17、l squeezing operation.將一個五邊行導板垂直地立于玻璃上，或以一個你感到自然的角度豎立，然后用刀片裁切窗膜的四周，留下約 1mm的邊。一定要在最后的擠壓操作前把窗膜邊部裁切完畢。Final squeezing終擠壓 安裝液對膜的表面 Spray washing and installation liquid on the film surface again. Squeezewater within the remaining 5cm range from inside to outside of the window film, and use the same pres

18、sure and angle and overlapping motion to squeeze the whole glass, or there will be water stain be left.再度向?qū)χ覂?nèi)的膜面噴灑清洗安裝液。擠壓在從內部范圍外的剩余5cm同的壓力及角度、重疊的動作擠壓整塊玻璃，否則會有水漬留下。Squeezing of side areas邊部吸水Use scrap-free towel to wrap the pentagonal guide plate or Teflon plate. Then starting from the position tha

19、t is 15cm away from the window frame, squeeze the water between the glass and window film with a table force, and carry out the process of water release and sucking. Because the towel can absorb water, change the positions continuously for absorb excess water completely and prevent the gravel from s

20、cratching the window films.用無屑紙巾包住五行導板或特富龍板，由距窗框15cm左右開始，以平穩的力度，將留在玻璃與窗膜間的水份擠壓出來，進行“放水”與“吮吸”工藝。由于紙巾可以吸水，應該不停地轉換位置以求將多余的水分吸盡，同時防止沙礫刮花窗膜。Window cleaning戶的清潔China中國Window film construction meithods and process太陽隔熱膜施工工藝及過程While all windows are installed with window films, spray a small amount of cleaner on the window glasses to remove installation liquid and other remainders. Use dry towels to wipe the window glasses to make the windows clean, smooth and glossy.當所有的窗戶都裝好窗膜后， 將少量不含阿摩尼亞的清